Hinges and Hardware 101 - Dimensioning a slotted hole

website dimension a slot Showing how to Dimension Tangentially and Arc Slots with Autodesk Inventor dimensioning a slot The slot dimension is 14 mm × 14 mm The overall dimension of the pentaband antenna is 10 cm × 10 cm The L-band antenna was

dimension a slot Under the Annotate Tab, pick Centerline Bisector Pick both nodes at the quadrants of the slot as shown below This will create a center line  Pre-selecting sketch curves and then applying slot creates slots of equal size across all curves, lines, or arcs, linked together with one single dimension You  To make the constraining of these slots easier just use a normal General Dimension and choose points to place your angular value When you grab

Share

Share

Link

Turn off sharing Copy link

See all details